7
c
ON
c
c
OK
1
2
3
4
5
6
7
PROG
0h 2 4 6 8 10 12 14 16 18 20 22 24
1
2
3
4
5
6
7
PROG
AUTO
c
0h 2 4 6 8 10 12 14 16 18 20 22 24
PERMANENT COMFORT MODE
In permanent comfort mode the unit maintains constantly the set point temperature.
It is possible to modify COMFORT set point temperature in 0,5ºC steps by pressing the
keys
“+”
or
“–”
.
Temperature range is from 5 to 30ºC.
When the heater consumes power, ON message is displayed.
Pressing the
“i”
will momentarily display the premises temperature.
PERMANENT ECONOMICAL MODE
In economical mode the unit maintains all the time the ECONOMICAL set point temperature.
Originally the economical set point temperature is the comfort set point temperature reduced by 3.5ºC.
See menu 1 of CONFIGURATION paragraph to modify the reduction or even to select economic set
point temperature.
Pressing the
“i”
key displays momentarily the premises temperature.
PERMANENT FROST PROTECTION MODE
In permanent frost protection mode the unit will operate when the premises temperature decreases lower
than 7ºC.
In this mode pressing the “i” key displays momentarily the premises temperature.
AUTOMATIC INTERNAL PROGRAMMER MODE
In this mode the unit performs commands of the internal programmer.
Programming
By default the program “Comfort fro 8h to 22h is applied for all days of the week.
To modify the program press the “PROG” key in this mode or in OFF mode.
Select the temperature level for the first time interval of the day 1 by pressing one of the following keys:
Pressing
displays two segments indicating COMFORT temperature.
Pressing
display one segment indicating ECONOMICAL temperature.
Pressing
does not display any segment, indicating FROST PROTECTION temperature.
After programming all 24 intervals for the DAY 1, press “OK” to pass to the DAY 2 of the week and repeat
the procedure.
Fast Programming
To copy the complete program from one day to another hold the “OK” key for 3 seconds.
