1.
Attach the flange (E) to the base (F) with
the three hex screws (J). Tighten them with
hex key (N) until secure.
2.
Fit the flange behind the desk. You may
need to remove the flange bolts if the space
between the desk and wall is too tight.
3.
Before you attach the clamp to the flange,
measure the thickness of the table or
desktop.
•
If the desktop is 0.4 to 2 inches thick, screw
the flange bolts into the top holes.
•
If the desktop is 2 to 3.3 inches thick,
remove the flange bolts from the top holes,
and screw them into the bottom holes.
To attach the clamp to the flange, fit the
wide end of the clamp holes over the flange
bolts, and press down on the clamp so it
securely sits on the flange bolts.
Important!
The clamp should rest on the flange
bolts. If the clamp is not parallel to the bottom
of the base, loosen the flange bolts until the
clamp rests entirely on them.
4.
Tighten the flange bolts with hex key (N)
until secure.
5.
With the flange flush against the edge of
the desktop, tighten the clamp locking knob
until the base is secured to the desktop.
Note:
The base arm should easily slide completely into
its socket. If it doesn’t, loosen the base arm setscrew
before reinserting the arm into its socket.
Attaching the Arm
9
1.
Fit the base arm (B) into the base socket.
2.
Use the screwdriver end of hex key (N) to tighten the base
arm setscrew until secure.
3.
Insert the monitor arm (A) into the base arm socket.
4.
Use the screwdriver end of hex key (N) to tighten the monitor
arm setscrew until secure.
Important!
Predrilled holes in the desktop should be between of 0.4 to 2.4 inches (10 to 60 mm)
in diameter.
1.
If you need to drill a hole in
the desktop, use a 3/8-inch
or 10 mm drill bit.
2.
Attach the notch cover
(G) to the bottom of
the base with the flat
hex screws (J). Make
sure the flat side of
the cover is even with
the edge of the base.
A
N
B
1X
A
1X
N
1X
3.
Cover the hex
screws with the
plastic caps (M).
4.
Place the base on the desktop, and insert the
carriage bolt (I) through the top of the base
socket and the hole in the desktop. Once it’s
inserted, make sure the bolt head sits flush
against the base’s hole.
5.
Beneath the desktop, slide the clamping
flange (H) onto the carriage bolt (I), and then
slide the washer (K) onto the carriage bolt.
6.
Screw the hex nut (L) onto the bolt. Tighten it
by hand, and then use the wrench (P) to fully
tighten the clamping flange to the desktop.
B
N
