GABRIEL KERAMIK AB
12 • STUDIO2
10
7
7
10
10
7
10
7
10
7
10
7
16
10
15
Assembly
Place the inner block (10) on top
of the firebox block
without
mortar joint
. Make sure that
this and the following blocks are
in level and do not ignore any
irregularities.
Seal/isulate the hollow space
under the outer ring as indicated.
Carefully centre and set the outer
blocks (7). Make sure that the
outer block is
one step ahead
of each inner block - set without
mortar - during the assembly. Outer
blocks and inner blocks must not
be in contact. Level vertically and
horizontally.
Check the control measurements,
see page 5.
For a better joint, wipe
the contact surfaces with
a squeezed sponge. After-
wards gently brush the
mortar joints with a wet
radiator brush.
All manuals and user guides at all-guides.com
