4. Usage and Maintenance
Prevention Measures for Wheel Fault
•
To cross over curbs or similar obstacles,
slow down your vehicle and drive in the
vertical direction of the obstacle as far as
possible.
•
Prevent the tires from touching grease, oil
and fuel.
•
Periodically inspect the tire damage state
(e.g. tire cut, crack, bump and other damage).
•
Periodically remove sundries embedded in
the tire tread.
Notice of Tire Storage
•
Make a mark on the tire to indicate the
direction of rotation before removing the tire.
Re-install the tire according to the mark to
keep the direction of rotation and the
dynamic balance state of the wheel
unchanged.
•
Store the removed wheels and tires in a cool
and dry place. It's better to store them in a
shaded place without direct sunlight.
•
Tires which have not been installed on the
wheels should be stored upright.
New Tires and Wheels
Carefully select new tire and wheel.
Please use tires of the same structural form and
size (rolling circumference) on all wheels. The tire
pattern shall be of the same specification as far as
possible.
Try not to replace one tire only. At least the two
tires on the same axle shall be replaced
simultaneously.
Do not use any tire whose effective size exceeds
the standard approved by our Company.
The tire and wheel combination from our
Company is recommended to be installed and
used.
Specifications of Rims and Tires
Rim:
6.5 Jx16 (apply to certain models)
6.5 Jx17 (apply to certain models)
7.0 Jx18 (apply to certain models)
Tire:
215/65R16 (apply to certain models)
215/60R17 (apply to certain models)
215/55R18 (apply to certain models)
Spare Tire:
T-type tire
Hint
The tire information label is located below
the B-pillar on the driver's side. Select the
rims and tires based on the recommended
size and type on the information label.
300
