ENGLISH
8
explicitely described in this manual) carried out a specialised and trained technical staff
only.
In case of replacement of the power supply cable, plug or terminals, perform the repair by
properly fixing the electric connections and the cable blocking strap that is located in the
control panel, to guarantee the resistance of the cable. Then reassemble the panel with
care to ensure the protection of the machine user.
Only the use of original accessories and spare parts supplied by the Manufacturer is
permitted, as only these offer the certainty that the machine will operate safely and
without any inconveniences. Do not use parts removed from other machines or other kits
as spares.
This machine has been designed and constructed to provide ten years' service from the
fabrication date shown on the rating plate. After this time, whether the machine has been
used or not, it should be disposed of according to current legislation in the country in
which it is used:
- The machine must be disconnected from the power supply, emptied of liquids and
cleaned;
- The product is classified as WEEE type special waste and is covered by the
requisites of the new environmental protection regulations (2002/96/EC WEEE). It
must be disposed of separately from ordinary waste in compliance with current
legislation and standards.
Special waste. Do not dispose of with ordinary waste.
Alternatively the machine must be returned to the Manufacturer for a complete overhaul.
If you decide to stop using the machine, you are recommended to remove the batteries
and dispose of them at an authorised collection centre.
You should also make sure that all parts of the appliance which could represent a hazard,
particularly to children, are made safe.
5.
HANDLING AND INSTALLATION
5.1
Lifting and carrying the packed machine
IMPORTANT
In all lifting operations make sure that the packed machine has been tightly
anchored to the pallet, in order to avoid any overturning or accidental falls.
Loading and/or unloading from the motor vehicles must be performed in an
adequately lighted environment.
The machine, which is packed on a wooden pallet by the Manufacturer, must be loaded
by means of proper handling machines (see EC Directive 2006/42 and subsequent
amendments and/or additions), onto the carrier and, once it has arrived at the appointed
destination, unloaded by similar means.
The packed machine body must be lifted only with a fork lift truck. Handle with care to
avoid bumps or overturnings.
5.2
Checking the machine on delivery
On delivery check with attention that the package and the machine are not damaged. In
the event that the machine has suffered any damages, report so to the carrier; before
Summary of Contents for GT 25 Series
