GAELCO - TUNING RACE
41
1) PROBLEM: The machine does not start when the mains switch is thrown.
•
Check the mains cable and its connections.
•
Check the fuses. Check the specifications are met. Check whether the fuses have
blown and that they have the correct current rating. The fault may have been caused by
an overload current.
•
Check the CPU connections
•
Check there is +5V DC in the power supply.
2) PROBLEM: There is something wrong with the screen colours and/or image.
•
Enter in Test Mode and adjust the monitor settings with the help of the screen test
(see Section 6.1)
3) PROBLEM: The game starts but the platform fails to move.
•
Check the emergency stop button is not pressed.
•
Check that the connections between the monitor casing and the game platform are not
loose and that the cables are undamaged.
•
Check that the frequency converters work properly (i.e. no error message)
•
Check the Power board (TRM-358): If the fuses have blown, it is likely that the power
transistors have short-circuited.
4) PROBLEM: The platform moves but does not match the game action.
•
Enter the MOTION SYSTEM screen in Test Mode and check that the platform is at its
highest point when taking the reading position of both motors. The reading should be
60. If this is not the case or the platform leans to one side, check the position
potentiometer following the procedure described in Section 9.5.
•
Check that the centering screws (TRM-829) are properly tightened on their respective
shafts.
•
Check that the elastics couplings (TRM-819) are properly connected.
5) PROBLEM: The platform moves very slowly, then stops.
•
Check the position potentiometers are working properly and that none of the cables
have broken.
6) PROBLEM: The machines do not work when they are linked up.
•
Check that the link cable properly connects the two machines.
•
Follow the instructions in Section 6.5 (Link Settings).
7) PROBLEM: There is no sound or it is of poor quality.
•
Change the volume on the Control Panel.
•
Carry out a sound test (see Section 6.5)
•
Check the connections.
8) PROBLEM: The gear shift fails.
•
Enter in
Controls
menu and check if the malfunction is permanent or not, holding the
lever pressed while the steering wheel is turned from one stop to the other..
•
Check the connections of the harness at both ends.
9.7 TROUBLESHOOTING PROCEDURES
TECHNICAL SERVICE: Tel (34)934173626
••
e-mail: tuningrace@gaelco.es
Summary of Contents for Tuning Race
