4
REV 5/22
GB745/206
-
500 S/N:1329 AND ABOVE
PLEASE CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS.
SPECIFICATIONS
Hand Held Weight
-
2.0 lbs. (.91 kg)
Weight
-
12 lbs. (5.44 kg)
Air pressure req'd
-
90
-
100 p.s.i. (6.2
-
6.9 bar) Max.
Air consumption
-
.30 SCF/cycle (8.50 L/cycle).
Hydraulic Oil
-
Automatic Transmission Oil,
Dexron® III, or equivalent.
Setting stroke
-
.500" (12.7mm)
Rated pull load
-
5,600 lbs. (24.9 kN)
Noise level
-
Less than 81.5 dB(A)
The GB745/206
-
500 Split Handle Pneumatic
-
Hydraulic Installation Tool is designed specifically for the efficient installation of blind
rivets and lockbolt fasteners. This tool
’
s unique "split" system provides the operator with a lightweight ergonomic tool for a fraction
of the cost of other cumbersome power rigs. It has a .500" (12.7mm) fastener setting stroke with a rated pull load of 5,600 lbs. (24.9 kN)
at 90 psi. (6.2 bar) air pressure at the air inlet.
The GB745/206
-
500 comes with 8 ft. (2.44 m) of hose and a remote actuator. The GB745/206
-
500 cylinder when held in your hand, weighs
just 2.0 lbs. (.91 kg)! While the entire split handle installation tool weighs 12 lbs (5.44 kg).
The GB745/206
-
500 Split Handle Pneumatic
-
Hydraulic Installation Tool operates on 90
-
100 psi. (6.2
-
6.9 bar) of air pressure, with 90 psi.
(6.2 bar) providing maximum efficiency. At 90 psi. (6.2 bar) of air pressure the GB745/206
-
500 does not exceed 81.5 dB(A) and consumes .30
SCF/cycle (8.50 L/cycle).
NOSE ASSEMBLIES ARE NOT FURNISHED WITH THE INSTALLATION TOOL AND MUST BE ORDERED SEPARATELY. (See nose assembly
selection chart on pg. 19).
DESCRIPTION
WARNING
:
Any other use is forbidden.
The GB745/206
-
500 can be operated between 0ºF
-
118ºF (
-
17.8ºC / 47.8ºC)
ENVIRONMENTAL USE
WARNING
:
Do not operate in an explosive atmosphere.
