background image

8

en

       Cleaning and maintenance

2

Cleaning and maintenance

Cleaning and maintenance

m

Warning – Risk of burns! 

The appliance becomes hot during operation. Allow the 
appliance to cool down before cleaning.

m

Warning – Risk of electric shock! 

Penetrating moisture may result in an electric shock. 
Clean the appliance using a damp cloth only. Before 
cleaning, pull out the mains plug or switch off the circuit 
breaker in the fuse box.

m

Warning – Risk of electric shock! 

Do not use any high-pressure cleaners or steam 
cleaners, which can result in an electric shock.

m

Warning – Risk of injury! 

Components inside the appliance may have sharp 
edges. Wear protective gloves.

Cleaning agents

To ensure that the different surfaces are not damaged 
by using the wrong cleaning agent, observe the 
information in the table. Do not use any of the following:

Harsh or abrasive cleaning agents,

Cleaning agents with a high alcohol content,

Hard scouring pads or cleaning sponges,

High-pressure cleaners or steam cleaners.

Wash new sponge cloths thoroughly before use.

Follow all instructions and warnings included with the 
cleaning agents.

Cleaning the metal mesh grease 
filters

These instructions apply to several appliance variants. It 
is possible that individual features are described which 
do not apply to your appliance.

m

Warning – Risk of fire! 

Grease deposits in the grease filter may catch fire.

Clean the grease filter at least every 2 months. 

Never operate the appliance without the grease filter.

Notes

Do not use any aggressive, acidic or alkaline 
cleaning agents.

When cleaning the metal mesh grease filters, also 
clean the holder for the metal mesh grease filters in 
the appliance using a damp cloth.

The metal mesh grease filters can be cleaned in the 
dishwasher or by hand.

By hand:

Note: 

You can use a special grease solvent for stubborn 

dirt. It can be ordered via the Online Shop.

Soak the metal mesh grease filters in a hot soapy 
solution. 

Clean the filters with a brush and then rinse them 
thoroughly.

Leave the metal mesh grease filters to drain.

In the dishwasher:

Note: 

If the metal mesh grease filters are cleaned in the 

dishwasher, slight discolouration may occur. This has no 
effect on the function of the metal mesh grease filters.

Do not clean heavily soiled metal mesh grease 
filters together with utensils.

Place the metal mesh grease filters loosely in the 
dishwasher. The metal mesh grease filters must not 
be wedged in.

Area

Cleaning agent

Stainless steel

Hot soapy water: 
Clean with a dish cloth and then dry 
with a soft cloth.

Clean stainless steel surfaces in the 
grind direction only.

Special stainless steel cleaning prod-
ucts are available from our after-sales 
service or from specialist retailers. 
Apply a very thin layer of the cleaning 
product with a soft cloth.

Painted surfaces

Hot soapy water: 
Clean using a damp dish cloth and dry 
with a soft cloth/towel.

Do not use any stainless steel cleaners.

Aluminium and plas-
tic

Glass cleaner: 
Clean with a soft cloth.

Glass

Glass cleaner: 
Clean with a soft cloth. Do not use a 
glass scraper.

Controls

Hot soapy water: 
Clean using a damp dish cloth and dry 
with a soft cloth/towel.

Risk of electric shock caused by pene-
trating moisture.

Risk of damage to the electronics from 
penetrating moisture. Never clean oper-
ating controls with a wet cloth.

Do not use any stainless steel cleaners.

Area

Cleaning agent

Summary of Contents for AC250190













Reviews: