en
Installation instructions
44
7.
Carefully loosen the screws on the frame cover.
Do not use any tools.
Note:
In order to prevent damage to the limit switch,
ensure that lock nuts do not fall into the opening in
the appliance.
8.
Place the frame cover down carefully.
9.
Open the cable cover at the side using a screw-
driver.
10.
Remove the cable on the appliance from the ter-
minal plug and the strain relief.
L
N
11.
ATTENTION!
There is a risk of damage to the appli-
ance if the cable is coiled up.
▶
Always secure the cable firmly using the strain
relief so that it does not coil up fully in the appli-
ance.
Secure the cable on the appliance using the strain
relief so that it does not coil up.
12.
Remove the on-site cable from the terminal plug
and remove the protective tube.
L
N
13.
Loosen the four cable clamps.
14.
Open the cable tensioner and pull out the cables.
15.
Thread the cables out of the frame cover.
