en
Installation instructions
14
8.
19 mm wall thickness: Open up the spacers on
both of the mounting parts.
9.
Screw the mounting parts to the body on the left
and right.
10.
Remove the limit stops from the bottom of the
mounting parts.
Preparing the appliance
1.
Insert the holders for the wall edging strip on the
outside rear of the appliance into the cut-outs and
fold them in to the centre of the unit.
2.
Connect the enclosed power cord to the appliance
and secure the stain relief.
Installing the appliance
1.
Fit the appliance in the cabinet , lock the fastening
bolts and attach the protective caps .
2.
Appliance width 90 cm: Pull the filter pull-out out
completely towards the front. Also use two screws
each on the left and right to screw the appliance to
the side upper cabinets from below.
3.
Adjust the wall closing strip to the clearance
between the appliance and the wall.
4.
Snap the wall closing strip into the holders.
5.
Fit the grease filters.
6.
Establish the pipe connection.
7.
Establish the electrical connection.
