Gaggenau AI240191, User Manual And Installation Instructions

Environmental protection and saving energy

 en

5

Condensation that flows back in may damage the ap-
pliance.

▶

The air extraction duct must be installed with a
gradient of at least 1° from the appliance.

If you put incorrect stress on the design elements, they
may break off.

▶

Do not pull design elements.

▶

Do not place objects on the design elements or
hang objects from them.

There is a risk of surface damage if you do not peel off
the protective film.

▶

Remove the protective film from all parts of the ap-
pliance before using for the first time.

Painted surfaces are easily damaged.

▶

Follow the cleaning instructions.
→ 

"Cleaning the appliance", Page 9

▶

Ensure that the painted surfaces are not scratched.

3  Environmental protection and saving energy

3.1 Disposing of packaging

The packaging materials are environmentally compat-
ible and can be recycled.

▶

Sort the individual components by type and dispose
of them separately.

3.2 Saving energy

If you follow these instructions, your appliance will use
less power.
Adjust the fan speed to the amount of steam pro-
duced during cooking.

¡

The lower the fan speed, the less energy is con-
sumed.
Only use the intensive mode as required.

If cooking produces large amounts of steam, select a
higher fan speed in good time.

¡

The odours are distributed around the room less.

Switch off the lighting if it is no longer required.

¡

When the lighting is switched off, it does not con-
sume any energy.

Clean or replace the filters at regular intervals.

¡

The effectiveness of the filter is retained.

Put the cooking lid on.

¡

The cooking vapours and condensation are re-
duced.

Only use the additional functions if required.

¡

Switching off additional functions reduces power
consumption.

4  Operating modes

You can use your appliance in air extraction mode or
circulating-air mode.

4.1 Air extraction mode

The air which is drawn in is cleaned by the grease fil-
ters and conveyed to the exterior by a pipe system.

The air must not be discharged into a
flue that is used for exhausting fumes
from appliances burning gas or other
fuels (not applicable to appliances that
only discharge the air back into the
room).

¡

If the exhaust air is to be conveyed
into a non-functioning smoke or ex-
haust gas flue, you must obtain the
consent of the heating engineer re-
sponsible.

¡

If the exhaust air is conveyed
through the external wall, a tele-
scopic duct should be used.

4.2 Air recirculation mode

The air which is drawn in is cleaned by the grease fil-
ters and an odour filter, and conveyed back into the
room.

To bind odours in circulating-air mode,
you must install an odour filter. The dif-
ferent options for operating the appli-
ance in circulating-air mode can be
found in our catalogue. Alternatively,
ask your dealer. The required accessor-
ies are available from specialist retail-
ers, from customer service or from the
Online Shop.