13
Operating the appliance
Cooking compartment
The cooking compartment has four shelf positions. The
shelf positions are counted from the bottom up.
Caution!
–
Do not place anything on the cooking compartment
floor. Do not cover it with aluminium foil. A build-up
of heat could damage the appliance.
–
Do not slide any accessories between the shelf
positions, or they may tip.
Always fully open the appliance door to the stop. In this
position, the open door will not swing back by itself.
Inserting accessories
The accessories are equipped with a locking function.
The locking function prevents the accessories from
tilting when they are pulled out. The accessories must
be inserted into the cooking compartment correctly for
the tilt protection to work properly.
When inserting the wire rack, check
▯
that the lug (a) is pointing downwards
▯
that the safety bar on the wire rack is at the back
and facing upwards.
Switching on
1
Set the required heating mode using the function
selector. The chosen heating mode and the default
temperature are displayed.
2
If you want to change the default temperature:
set the required temperature with the rotary
selector.
The preheating symbol
’
appears on the display. The
bar continuously shows the preheating status. When the
set temperature is reached, a signal sounds and the
preheating symbol
’
goes off.
Note:
The oven interior lighting stays switched off at a
temperature setting below 70°C
Switching off:
Turn the function selector to
0
.
Rapid heating
With the "Rapid heat-up" function, your appliance
reaches the desired temperature particularly quickly in
the top heating, bottom heating and top/bottom heating
types of heating.
To ensure an even cooking result, do not place your
food in the cooking compartment until "Rapid heat-up"
is complete and the
’
heat-up symbol goes out.
Note:
The "Rapid heat-up" function is preset in the
factory settings. In the basic settings, you can select
’
Rapid heat-up or
“
Heat-up.
Safety shut-off
For your protection, the appliance is equipped with an
automatic safety shut-off. Any heating process is
switched off after 12 hours if the oven is not operated in
this time. A message appears in the display.
Exception:
The long-term timer has been programmed.
Set the function selector to
0
, then the appliance can be
operated again as usual.
D
D