12
Combination with an oven
In the case of the BS 474/475 and BS 484/485
appliance versions, the control panel is at the bottom.
As a result, these models are particularly suitable for
installation over a Gaggenau Series BO 4.. oven.
Fit the Combi-steam oven first and then the oven.
For an installation depth of 21
5
/
8
" (550 mm), position
the water hoses and the connecting cable in the area of
the housing cut-out.
The rear of the BO 4.. ovens has a bevelled corner.
Route the Combi-steam oven's connecting cable and
supply and drain water hoses downwards to the
connection points on the rear left in the kitchen unit.
If the hoses are not routed in the corner on the rear left
in the kitchen unit, when installing the appliance over an
oven the kitchen unit's body must be pulled forward by
at least 1
\
" (35 mm) and side paneling or a trim must
be inserted.
Combination with warming drawer,
width 24" (60 cm)
Fit the warming drawer first. Pay attention to the
warming drawer's installation instructions.
Slide the oven onto the warming drawer and into the
built-in cabinet. When sliding it in, do not damage the
warming drawer's panel.
Combination with warming drawer,
width 30" (76 cm)
Installation BO/BS (width 30" (76 cm)) over warming
drawer WS only with dimensionally stable partition floor.
Check the Installation
9
WARNING
Before you plug in an electrical cord or turn on
power supply, make sure all controls are in the
OFF position.
Switch on the circuit breaker.
Verify that elements function properly.
Removal
1
Disconnect the appliance from the power supply.
2
Undo the fastening screws.
3
Raise the appliance slightly and pull it out
completely.
PLQȾ
PLQȿ
PLQȤɊȫȰ
ɀ
èȢɊȫȰ
èèɊȫȰ
ȤɊȫȰ
èçɊȫȰ
ȿ
èèɊȫȰ
Ƚ
ɀ
èèɊȫȰ
Ƚ
PP
çɊȫȰ
èɊȮ
ë
PLQȾ
PLQȿ
çɊȫȰ
PLQȤɊȫȰ
èȢɊȫȰ
Ⱦ
ȿ
èèɊȫȰ
Ƚ
ɀ
èèɊȫȰ
Ƚ
ë
èèɊȫȰ
PP
èçɊȫȰ
ɀ
çɊȫȰ
