40
en-us
Wireless cooking sensor
3.
Detection successful:
The wireless temperature sensor
is detected within a few seconds. Three short beeps
sound and the
¨
symbol changes from orange to
white. The cooking sensor indicators on the cooking
zones go out.
Detection failed:
Five beeps sound. The
¨
symbol
changes immediately from orange to white and the
cooking sensor indicators on the cooking zones go
out.
▯
The cooking functions are made available as soon as
the wireless cooking sensor has been connected to
the control panel correctly.
▯
If there is a fault with the wireless cooking sensor, the
connection may not be established correctly for the
following reasons:
–
Bluetooth communication error.
–
You have not pressed the
¨
symbol on the
cooking sensor within 30
seconds of selecting
the cooking zone.
–
The battery in the wireless cooking sensor is
almost flat.
Reset the wireless cooking sensor and repeat the
connection procedure.
▯
If there are problems with the connection due to a
transmission error, repeat the connection procedure.
If no connection can be established, inform customer
service.
Resetting the wireless cooking sensor
1.
Touch and hold the
¨
symbol for approximately 8-
10 seconds.
While you are doing this, the temperature sensor's
LED indicator will light up three times. When the LED
lights up for the third time, it will start to reset the
temperature sensor. At this point, you will need to lift
your finger off the symbol.
Once the LED goes out, this means that the wireless
temperature sensor has been reset.
2.
Repeat the connection process from point 2.
Cleaning
Do not clean the wireless cooking sensor in the
dishwasher.
Wireless cooking sensor
Clean with a damp cloth. Never put in the dishwasher,
never get wet.
If the wireless cooking sensor is not used, remove it from
the cookware and keep it in a clean, safe place and not
near heat sources.
Silicone patch
Clean and dry before attaching to the wireless cooking
sensor. Suitable for dishwashers.
Note:
Do not leave utensils with the silicone patch in
soapy water for long periods of time.
Cooking sensor window
The sensor window must always be clean and dry.
Proceed as follows:
▯
Remove dirt and oil splatters regularly.
▯
For cleaning, use a soft cloth or Q-tips and window
cleaner.
Notes
▯
Do not use abrasive cleaning products such as
scouring pads, scrubbing brushes or cream cleaners.
▯
Do not touch the sensor window with your fingers.
This may make it dirty or scratch it.
Changing the battery
If the cooking sensor does not light up when the symbol
is pressed, the battery no longer has a charge.
Replacing the battery:
1.
Remove the silicone cover from the lower section of
the cooking sensor casing and remove both screws
using a screwdriver.
Summary of Contents for CI 282 601
Page 1: ...DJJHQDX Use and care manual CI 282 601 Cooktop...
Page 2: ...2...
