58
en-us
Faults – what to do?
Notes
▯
If
“
appears on the display, the sensor for the element
in question must be held down in order to be able to
read the fault code.
▯
If the fault code is not listed in the table, disconnect
the cooktop from the power supply, wait 30 seconds,
and then reconnect it again. If the display appears
again, contact Customer Support and tell them the
precise fault code.
▯
If a fault occurs, the appliance will not switch to
standby mode.
Cookware Test
Cookware Test
This function can be used to check the speed and quality
of the cooking process depending on the cookware.
The result is a reference value and depends on the
properties of the cookware and the element being used.
1.
With the cookware still cold, fill it with approx. 200 ml
of water and place it on the center of the element with
the diameter that most closely matches that of the
base of the cookware.
2.
Go to the basic settings and select the
™ˆ
setting.
3.
Touch the settings range.
A
will flash on the element
display.
The function has now been activated.
“‰ƒ‹„
The temperature sensor has overheated
and all the cooking zones have been
switched off.
When you are not using the temperature sensor,
remove this from the cookware and store it far away
from the cooking zones or heat sources. Switch the
cooking zones back on.
“‰ƒ‹…
The battery in the temperature sensor is
flat.
Replace the 3
V CR2032
battery. See the section
entitled "Changing the battery".
“‰ƒ‹†
The temperature sensor is no longer
connected.
Switch the function off and then on again.
“‰ƒ‹‡
The temperature sensor is broken/
faulty.
Inform the technical customer service.
The temperature sen-
sor display does not
light up.
The temperature sensor does not react
and the display does not light up.
Replace the 3
V CR2032
battery. See the section
entitled "Changing the battery".
If this does not solve the problem, press and hold the
symbol on the temperature sensor for eight seconds
and then reconnect the temperature sensor to the
cooktop.
If the problem still persists, contact the technical cus-
tomer service.
The indicator on the
temperature sensor
flashes twice.
The battery in the temperature sensor
has almost run out. You may be inter-
rupted the next time you cook by the
battery running out.
Replace the 3
V CR2032
battery. See the section
entitled "Changing the battery".
The indicator on the
temperature sensor
flashes three times.
The temperature sensor is no longer
connected.
Press and hold the symbol on the temperature sensor
for eight seconds and then reconnect the tempera-
ture sensor to the cooktop.
“Š‹‹‹
“Š‹‚‹
The operating voltage is incorrect and
outside of the normal operating range.
Contact your electricity supplier.
—…‹‹
The cooktop is not connected properly. Disconnect the cooktop from the mains power supply.
Make sure that it has been connected as shown in the
circuit diagram.
š“
Demo mode is activated.
Disconnect the cooktop from the mains power supply.
Wait 30 seconds and then reconnect. Touch any
touch control within the next three minutes. Demo
mode is switched off.
Display
Possible cause
Solution
Do not place hot cookware on the control panel.
Summary of Contents for CI 282 601
Page 1: ...DJJHQDX Use and care manual CI 282 601 Cooktop...
Page 2: ...2...
