6
Prepare Installation Space
Create the cut-out in the countertop according to the
installation diagram. The angle of the cut surface to the
countertop must be 90°.
The lateral cut-out edges must be flat in order to ensure
that the retaining springs are positioned properly on the
appliance. With multi-layered countertops, secure strips
laterally in the cut-out if necessary.
After creating cut-out, remove shavings. Seal cut
surfaces in a heat- and water-resistant manner.
Observe minimum distance between device underside
and cabinet surfaces of
3
/
8
" (10 mm).
The worktop into which the cooktop is installed must be
heat-resistant up to 140° F (90 °C).
The worktop must be reinforced if it is less than
4
/
5
inch
(20 mm) thick.
If the thickness of the worktop into which the cooktop is
installed does not comply with the specifications,
reinforce the worktop using a fire- and water-resistant
material until it reaches the minimum thickness.
Otherwise, sufficient stability cannot be assured.
▯
The worktop into which the cooktop is installed
should withstand loads of approx. 133 lbs (60 kg).
▯
Only check the evenness of the cooktop after it has
been installed.
For flush installation in tiled countertops:
Note:
If necessary, raise the support surfaces using
heat and water resistant strips.
Cutout dimensions for 30" cooktops
Model: CI 282 610
Cutout dimensions for 36" cooktops
Model:
CI 292 610
[
¡
PLQ
PP
PLQ
PLQ
[
¡
PLQ
PP
PLQ
PLQ