5080004686 en 06.05 EB
11
6.3 Installation and removal
Installation
Proceed as follows:
–
Produce the recess for the appliance
in the
worktop. Proceed as shown in the installation
sketch and the dimension table. (Fig. 9) The
angle between the cut surface and the worktop
must be 90°. (Fig. 10)
–
Mark the centre of the recess exactly.
Secure
the securing rails on both sides in the recess.
Make sure that the lugs of the securing rails lie on
the worktop and that the centre marking on the
securing rails is precisely flush with the centre
marking on the worktop.
Note:
When installing the appliance in granite
or marble worktops, have the holes produced by
a specialist or stick on the securing rails with a
temperature-resistant 2-component adhesive
(metal on stone).
–
Secure the earthing connector
and then the
two 6-pole connectors according to the colour
marking on the cooker or the control panel
installed beneath the appliance.
–
Lower the appliance into the worktop
. Make
sure that the engaging lugs on the appliance
lie exactly on the clamping springs. Press the
appliance firmly into the worktop. The engaging
lugs on the appliance “snap" into the clamping
springs. (Fig. 11)
Removal
Push out the appliance from below and in the
upward direction. Do not attempt to remove the
appliance from above! This will involve a risk
of breaking it!
560
±
1
520
610
4
40
490
±
1
min.30
min. 50
Fig. 9
Fig. 10
Fig. 11
90°
