Troubleshooting
en
55
Errors
Cause
Troubleshooting
Water marks on plastic parts.
Due to laws of physics droplet
formation on plastic surfaces
is unavoidable. After drying
water marks are visible.
▶
Select a more intensive programme.
▶
Position tableware at an angle.
"Arranging tableware", Page 36
▶
Use rinse aid.
▶
Set the water softening system
higher.
"Setting water softening system",
Wipeable or water-soluble
coatings are present inside
the appliance or on the door.
Detergent substances are de-
posited there. These coatings
cannot generally be removed
with chemicals.
▶
Change your detergent
.
▶
Clean the appliance mechanically.
White coating is deposited in
the appliance interior.
1.
Set the water softening system cor-
rectly.
"Setting water softening system",
In most cases you will need to in-
crease the setting.
2.
Change your detergent if required.
Special salt dispenser is not
screwed tight.
▶
Screw the special salt dispenser tight.
Stubborn white coatings are
present on tableware, inside
the appliance or the door.
Detergent substances are de-
posited there. These coatings
cannot generally be removed
with chemicals.
▶
Change your detergent
.
▶
Clean the appliance mechanically.
The hardness range is set in-
correctly or the water hard-
ness is greater than 62°°E
(8,9 mmol/l).
▶
Set the Water softening system
add special salt.
3in1/organic/eco detergent is
not effective enough.
▶
Set the Water softening system
and use separate detergents (propri-
etary detergent, special salt, rinse
aid).
Too little detergent is being
used.
▶
Increase the amount of detergent
used or change Detergent
Washing programme selected
too weak.
▶
Select a more intensive washing pro-
gramme.