Troubleshooting
en
57
Errors
Cause
Troubleshooting
Plastic parts inside the appli-
ance are discoloured.
Plastic parts inside the appli-
ance may become discol-
oured during the life of the
dishwasher.
▶
Discolouration can come about and
will not impair functioning of the ap-
pliance.
Plastic parts are discoloured.
Washing temperature is too
low.
▶
Select a programme with a higher
washing temperature.
Tableware has been pre-
cleaned too intensely. The
sensors chose a weaker pro-
gramme. Stubborn soiling
cannot be entirely removed.
▶
Only remove large remnants of food
and do not prerinse tableware.
▶
Adjust the sensitivity of the sensors.
Removable streaks are
present on glasses, glassware
with a metallic appearance
and cutlery.
Amount of rinse aid to be dis-
pensed is set too high.
▶
Set the rinse aid system to a lower
setting.
"Setting the amount of rinse aid",
No rinse aid has been added.
▶
Detergent residue is present
in the final rinse. Lid of the de-
tergent dispenser is blocked
by tableware items and will
not open fully.
1.
Arrange tableware in the top basket
tableware so the tab collecting tray is
not obstructed by tableware.
"Arranging tableware", Page 36
Items of tableware are blocking the
dispenser lid.
2.
Do not place tableware or fragrance
dispensers in the tablet collecting
tray.
Tableware has been pre-
cleaned too intensely. The
sensors chose a weaker pro-
gramme. Stubborn soiling
cannot be entirely removed.
▶
Only remove large remnants of food
and do not prerinse tableware.
▶
Adjust the sensitivity of the sensors.
Irreversible clouding of glass-
ware.
Glasses are not dishwasher-
proof, only suitable for dish-
washers.
▶
Use dishwasher-proof glasses.
▶
Avoid a lengthy steam phase (stand-
ing time after wash cycle ends).
▶
Use a programme with a lower tem-
perature.
▶
Set the softening system to the water
hardness.
"Setting water softening system",
▶
Use detergent with a glass protection
component.
