Water softening system
en
31
1.
Unscrew the lid of the dispenser for
special salt and remove.
2.
On initial start-up: Fill the dispenser
right up with water.
3.
Note:
Only use special salt for dish-
washers.
Do not use salt tablets.
Do not use table salt.
Add the special salt to the dis-
penser.
a
Funnel
1
Fill the dispenser right up with spe-
cial salt. The water in the dispenser
is displaced and forced out.
4.
Place the lid back on the dispenser
and turn to close.
Switching off water softening
system
If you find the special salt refill indicator
irritating, e.g. when using combined de-
tergents with salt replacement sub-
stances, you can switch the salt refill in-
dicator off.
Note
To avoid damage to the appliance, only
switch off the water softening system in
the following cases:
¡
The water hardness is max. 26 °E
and you are using combined deter-
gents with salt replacement sub-
stances. According to manufactur-
ers, combined detergents with salt
replacement substances can gener-
ally only be used up to a water hard-
ness of 26°°E without adding spe-
cial salt.
¡
The water hardness is 0 - 8°°E. You
do not need to use special salt.
1.
To open the basic settings, press
for approx. 3 seconds.
2.
Press repeatedly until the display
shows "Water hardness".
3.
Press or repeatedly until the
display shows 0 - 6.
4.
To save the settings, press
for
approx. 3 seconds.
a
The water softening system is
switched off and the salt refill indic-
ator is deactivated.
Regeneration of the water
softening system
In order to obtain fault-free function of
the water softening system, the appli-
ance performs reheating of the water
softening system at regular intervals.
Regeneration of the water softening
system takes place before the end of
the main rinse cycle in all programmes.
It will increase the run time and con-
sumption values, e.g. water and electri-
city.
1
Depending on the appliance specifications
