29
Operating the Dishwasher
en-us
Time display
The wash cycle time is determined during the wash
cycle by the water temperature, the amount of dishes, as
well as the degree of soiling and may vary (depending
on the selected wash cycle). You can change the time
display into time of day or hours/minutes so that the
remaining cycle time of the wash cycle appears in the
display window “Ready at” (for example 15:20 o’clock)
or “Ready in” (for example 3:25 hours).
Sensor setting
The wash cycle sequence is optmised in Auto wash
cycles with the aid of sensors. The sensors adjust the
wash cycle strength of Auto wash cycles depending on
the amount and type of soiling. You can adjust the
sensitivity of the sensors in 3 stages.
Standard:
This setting is ideal for a mixed load and
heavily soiled utensils, but also saves energy and water.
Sensitive:
This setting adjusts the wash cycle strength
for the effective removal of food remnants, even if the
amount of soiling is low. The energy and water
consumption is adjusted accordingly.
Very sensitive:
This setting adjusts the wash cycle
strength for difficult conditions of use, for example
firmly dried on food remnants. This setting is
recommended if using biological or eco detergents
which contain lower amounts of active agents. The
energy and water consumption is adjusted accordingly.
extraDry
The final rinse uses a higher temperature which
improves the drying result. The cycle time may increase
slightly. (Caution if utensils are delicate!) You can
switch the extraDry function on or off.
Eco forecast
When Eco forecast is activated, the average water and
energy consumption of the selected wash cycle is
briefly displayed in the digital display
@
.
AutoPowerOff
(Switching off automatically after the
end of the wash cycle)
To save energy, the dishwasher is switched off 1 minute
after the wash cycle ends. You can also change this
setting.
Possible settings are:
▯
off:
The appliance does not switch off automatically.
▯
After one minute:
The appliance switches off after
1 minute.
▯
After two hours:
The appliance switches off after
2 hours.
Infolight *
While the wash cycle is running, a light spot shines
on the floor under the appliance door. Do not open the
appliance door until the light point is no longer visible
on the floor. If the appliance door is not completely
closed, the light spot flashes *. If the appliance
is installed at eye-level, with flush furniture front,
the light point is not visible. You can switch the Infolight
on or off.
* optional feature which may or may not be included with
your dishwasher
Changing start wash cycle
You can change the “Start wash cycle” setting.
Tone volume
The end of the wash cycle is indicated by a buzzer. You
can also change this setting.
Button volume
When you are operating the dishwasher, a signal
sounds whenever a button is pressed. You can control
the volume of the signal. If you do not like the button
volume, you can switch it off.
