21
Operating the appliance
1
Open the door.
2
Switch on ON/OFF switch
(
.
3
Hold down programme button
#
and press
START button
`
until
•
:
‹
...
is indicated on the digital display.
4
Release both buttons.
The LED for button
#
flashes and the digital
display
h
displays the factory setting
•
:
‹…
.
5
Keep pressing programme button
#
until the
value
˜
:
‹
... is indicated on the numerical display
h
.
To change the setting:
1
Press programme button
3
.
Each time the button is pressed, the set value
increases by one level; when the value of
˜
:
‹ƒ
has been reached, the display jumps back
to
˜
:
‹‹
.
2
Press START button
`
.
The set value is saved.
3
Close the door.
Switching off the appliance
Short time after the end of the programme:
1
Open the door.
2
Switch off ON/OFF switch
(
.
3
Turn off the tap (not applicable if Aqua-Stop
fitted).
4
Remove the utensils when they have cooled down.
Note
When the programme ends, leave the appliance
to cool down a while before opening it. This will
prevent steam from escaping and causing long-term
damage to your built-in furniture.
Interrupting the programme
1
Open the door.
2
Switch off ON/OFF switch
(
.
The LEDs go out. The programme is saved.
If the door was opened on an appliance which has
a warm water connection or is heated, first leave
the door ajar for several minutes and then close.
Otherwise, expansion (pressure) may cause the
appliance door to spring open or water to run out
of the appliance.
3
To continue the programme, switch on the ON/
OFF switch
(
again.
4
Close the door.
Terminating the programme
Terminating the programme (Reset)
1
Open the door.
2
Press START button
`
for approx. 3 sec.
The numerical display
h
indicates
‹
:
‹‚
.
3
Close the door.
The programme sequence lasts approx. 1 min. On
the digital display
h
is indicated
‹
:
‹‹
.
4
Open the door.
5
Switch off ON/OFF switch
(
.
6
Close the door.