31
Installation and connection
Delivery
Your dishwasher has been checked thoroughly in the
factory to ensure that it is in working order. This may
cause small water stains. These will disappear after
the first wash cycle.
Technical specifications
Weight:
max. 45 kg
Voltage:
220–240 V, 50 Hz or 60 Hz
Connected load:
2000–2400 W
Fuse:
10/16 A (UK 13A)
Power input:
off mode (Po)* 0.10 W
left on mode (Pl)* 0.10 W
*according to regulations (EU) nos. 1016/2010 and
1059/2010
Additional functions and settings may increase the
power input.
Water pressure:
at least 0.05 MPa (0.5 bar), maximum 1 MPa (10 bar).
At a higher water pressure: connect pressure-
reducing valve ahead.
Inlet rate:
minimum 10 litres/minute
Water temperature:
cold water; hot water max. temperature 60 °C.
Capacity:
9–10 place settings (depending on model).
Installation
The required installation dimensions can be found in
the installation instructions. Level the appliance with
the aid of the height-adjustable feet. Ensure that the
appliance is situated securely on the floor.
▯
A built-under or integrated appliance which is
installed subsequently as a free-standing
appliance must be secured to prevent it from
overturning, e.g. by screwing it to the wall or by
installing it under a continuous worktop which is
screwed to adjacent cupboards.
▯
The appliance can easily be installed in a fitted
kitchen between wooden and plastic walls.
Waste-water connection
1
The required work sequence can be found in the
installation instructions. If required, fit a siphon
with an drainage connection.
2
Connect the waste-water hose to the drainage
connection of the siphon with the enclosed parts.
Ensure that the drainage hose is not kinked,
crushed or twisted and that there is no cover plate
in the drainage to prevent the waste water from
flowing out!
