32
Installation and connection
Drinking water connection
1
Fasten the drinking water connection to the tap
according to the installation instructions using
the enclosed parts.
Ensure that the drinking water connection is not
kinked, crushed or twisted.
2
When replacing the appliance, always use a new
water supply hose.
Water pressure:
At least 0.05 MPa (0.5 bar), maximum 1 MPa (10 bar).
At a higher water pressure: connect pressure-
reducing valve ahead.
Inlet rate:
Minimum 10 litres/minute
Water temperature:
Cold water preferred; hot water max. temperature
60 °C.
Warm water connection *
Warm water connection
* depending on model
The dishwasher can be connected to cold or hot water
up to max. 60 °C.
Connection to hot water is recommended if the hot
water can be supplied by energetically favourable
means and from a suitable installation, e.g. solar
heating system with circulation line.
This will save energy and time.
The hot water setting
‘
:
‹‚
allows you to adjust your
appliance optimally to operation with hot water.
It is recommended to have a water temperature
(temperature of the incoming water) of at least 40 °C
and no more than 60 °C.
It is not recommended to connect the appliance to hot
water if the water is supplied from an electric boiler.
Setting hot water:
1
Open the door.
2
Switch on ON/OFF switch
(
.
3
Hold down programme button
#
and press
START button
`
until
•
:
‹
... is indicated on the
digital display.
4
Release both buttons.
The LED for button
#
flashes and the digital
display
h
displays the factory setting
•
:
‹…
.
5
Press programme button
#
until the factory set
value
‘
:
‹‹
is indicated on the digital
display
h
.
To change the setting:
1
By pressing the
3
button, you can switch the
hot water setting off
‘
:
‹‹
or on
‘
:
‹‚
.
2
Press START button
`
.
The set value is saved.
3
Close the door.