33
Installation and connection
Electrical connection
▯
Connect the appliance to an alternating current
only, ranging from 220 V to 240 V and 50
Hz or 60 Hz via a correctly installed socket with
protective earth conductor. See rating plate
for required fusing
92
.
▯
The socket must be near the appliance and freely
accessible following installation.
If the plug is not freely accessible, an allpole
disconnector with a contact opening of at least 3
mm must be fitted on the installation side
to satisfy the relevant safety instructions.
▯
The connection may be modified by technicians
only.
▯
A power cord extension may be purchased from
customer service only.
▯
Use only a residual current operated circuit-
breaker which features the symbol
‚
. Only this
extension guarantees compliance with
the currently valid regulations.
▯
The appliance features a water damage
protection system. Please note the system will not
function
unless
the power supply is connected.
Removing the appliance
Also observe the sequence of worksteps here.
1
Disconnect the appliance from the power supply.
2
Turn off the water supply.
3
Undo the waste water and drinking water
connection.
4
Loosen fastening screws for the furniture parts.
5
If fitted, remove the base panel.
6
Pull out the appliance, carefully pulling the hose
behind.