Gaggenau DI 230-130, Operating Instructions Manual

aus

16

Washing dishes

 Reduce costs!

If only a small number of dishes have
been loaded into the dishwasher, selecting
a programme that operates at the next
lowest temperature will usually suffice.

Programme data

The stated programme data are based on
standard operating conditions.  The values
can vary considerably according to:

different amounts of dishes
temperature of mains water supply
pressure of mains water supply
ambient temperature
fluctuations in mains voltage
machine-related factors (e.g.
temperature, water volume, ...).

Switching on the appliance

Close the door.
Turn on the tap fully.
Rotate programme selector 

3

 to the

required programme.
Switch on the main switch 

1

.

The programme sequence display 

5

lights up, the programme sequence starts
automatically.

End of programme

The programme ends when
the Programme progress indicator

5

 has gone out and

the End-of-programme indicator

6

 illuminates. When the programme

ends, the ”Top basket washing” function
is de-activated if required (only some
models).
Several minutes after the programme has
ended:

Open the appliance door.
Wait until the dishes have cooled down
and then remove.

When the programme has ended, you can
either switch off the appliance or restart it
with the same or another programme.

Switching off the appliance

Several minutes after the end
of the programme:

Switch off the main switch 

1

.

”End of programme” display 

6

goes out.
Turn off the tap
(does not apply to Aqua Stop).
It is not necessary to adjust the
programme selector.
Remove the utensils when they have
cooled down.

Interrupting the programme

Set the main switch 

1

 to OFF.

Indicator lights extinguish.

If the hot water was switched ON or the
appliance has already heated up and then
the appliance door opened, leave the door
ajar for several minutes and then close.
Otherwise, the appliance door may fly
open due to expansion.

In order to resume the programme, set
the main switch to ON again.

Terminating the programme
(Reset)

Only when the main switch is on:
Rotate programme selector to the
Reset position.
The programme sequence lasts
approx. 1 min.
When the programme has run,
switch off the main switch 

1

.

To restart, rotate the programme selector

3

 to the required programme. Switch on

the main switch 

1

. The programme

sequence starts automatically.