Gaggenau DI 460-131, Operating Instructions Manual

15

Switching off the appliance

Short time after the end of the programme:

Open the door.
Switch off ON/OFF switch 

1

.

Turn off the tap (not applicable if Aqua-Stop fitted).
Remove the utensils when they have cooled down.

Warning

At the end of the programme please open the door fully
and not partially when emptying the dishwasher. Any
escaping water vapour could damage sensitive
worktops.

Interrupting the programme

Open the door.
Switch off ON/OFF switch 

1

.

The LEDs go out. The programme is saved. 
If the door was opened on an appliance which has a
warm water connection or is heated, first leave the
door ajar for several minutes and then close.
Otherwise, expansion (pressure) may cause the
appliance door to spring open or water to run out of
the appliance.
To continue the programme, switch on the ON/OFF
switch

1

 again.

Close the door.

Terminating the programme (Reset)

Open the door.

Press START button 

10

 for approx 3 sec. 

 is

indicated on the digital display 

3

.

Close the door.
The programme sequence lasts approx. 1 min.

 is indicated on the digital display 

3

 (buzzer

sounds).
Open the door.
Switch off ON/OFF switch 

1

.

Close the door.

Changing the programme

When the START button 

10

 has been pressed, the

programme cannot be changed.
The only way a programme can be changed is by
Cancel programme (reset).

Intensive drying

The final rinse uses a higher temperature which
improves the drying result. The running time may
increase slightly. (Caution if utensils are delicate!)

Open the door.
Switch on ON/OFF switch 

1

.

Hold down programme button 

A

 and press START

button

10

 until on the digital display 

 is

indicated.
Release both buttons.
The LED for button 

A

 flashes and the digital

display displays the factory setting 

.

Press programme button 

A

 until the factory set

value

 is indicated on the digital display 

3

.

To change the setting,

Press the button 

C

 to switch intensive drying on

 or off

.

Press START button 

10

.

The set value is saved.
Close the door.

Interior light

*

20

The interior light comes on when the door is opened
irrespective of whether the ON/OFF switch 

1

 is

switched on or off. When the door is closed or ajar, the
light is off.

Open the door.
Switch on ON/OFF switch 

1

.

Hold down programme button 

A

 and press START

button

10

 until 

 is indicated on the digital

display.
Release both buttons.
The LED for button 

A

 flashes and the digital

display displays the factory setting 

.

Press programme button 

A

 until the factory set

value

 is indicated on the digital display 

3

.

To change the setting,

Press the button 

C

 to switch the interior light off

 or on 

.

Press START button 

10

.

The set value is saved.
Close the door.

* depending on model