ENGLISH - 9
ENGLISH
www.gaggenau.com/us
DRAIN HOSE CONNECTION
Drain Hose
• Before beginning, turn off the water
supply!
• The access hole for the drain hose should
be 1.25” (32 mm) diameter.
• Use the hose clamps and rubber
connection hose (Figure 3) to connect
the drain hose to the sink, disposer or
air gap (Figure 14).
Figure 14
G, Fig 3
Drain Hose
Connected
to Sink
Be sure to follow your national
and local codes at all times.
Openings for drain lines must be
installed in the marked areas as
shown in Figures 8 and 9 to avoid
interference with the dishwasher
frame or other components.
Drain Hose
in Sink
with Air
Gap &
Disposer
Figure 13
min.
20”
(500
mm)
clearance
to
floor
Air Gap
Rubber
Connector
Trap
disposer
Figure 12
Drain Hose
in Sink with
Air Gap/ No
Disposer
Air Gap
Rubber
Connector
Trap
min.
20”
(500
mm)
clearance
to
floor
THESE INSTALLATION
INSTRUCTIONS ARE
INTENDED FOR USE BY
QUALIFIED INSTALLERS
Failure to provide the proper drain
connection height, 20” (508mm)
above floor level with high loop or
air gap, will result in improper
draining
of
the
dishwasher.
Improper draining may cause
damage to the dishwasher.
CAUTION
