31
Installing the anti-tilt device
Do not open the doors of your IK 300 until you
have fitted the anti-tilt device 6 (Fig. 5). If the
anti-tilt device has not been fitted, the IK 300
may tilt forwards when the doors are opened.
To be able to fit the stabiliser, you must first
remove the ventilation grille 4 (Fig. 19).
Release retaining clip 5.1 and remove the anti-tilt
device, see Fig. 4.
Now fit the stabiliser 6 back on the two mounting
pins 5.2 in the vertical position and secure it with
the enclosed nuts, as shwon in Fig. 5.
Note:
Do not remove the stabiliser again until the
IK 300 has been completely installed
(see fig. 13/14/22/23).
The stabiliser must always be refitted before
removing the appliance.
Once the IK 300 has been firmly secured, you
can remove the internal packaging and the
transport locks inside the appliance.
Dimensions of the IK 300
The IK 300 is designed so that it can be fully
integrated into any kitchen. Both the height and
the depth of the base panel can be adjusted.
Figure 6, alongside, shows the dimensions of the
IK 300 without the decorative wooden doors.
When adjusting the base height, the difference
must be added to the overall heights 860 mm
and 1980 mm.
Explanation of Figure 7
The dimensions in Fig. 7 apply to feet rollers
which have been completely screwed in.
S = Base height
A = Height of the exhaust cross-section should
not be less than 130 mm (from 80 mm to
130 mm possible)
Height of the feet rollers can be adjusted from
0 to 70 mm.
21 = Decor door
22 = Base plate
23 = Floor
24 = Castors
90000260170.QXD 18.04.2007 14:23 Uhr Seite 31 (1,1)
