22
Ice maker
x
Fault
Possible cause
Remedial action
The ice maker doesn’t work.
Ice maker is not connected to the mains
supply.
Call customer service.
Ice maker does not contain any fresh
water.
Ensure that the water is properly connected.
The freezer compartment temperature is
too warm.
Check freezer compartment temperature and, if
required, set slightly colder.
The ice maker does not make
enough ice or the ice is
deformed.
The appliance or ice maker has only just
been switched on.
Approx. 24 hours is needed until ice production
starts.
A lot of ice has been taken.
Approx. 24 hours is needed until the ice cube
container is filled again.
Low water pressure.
Connect the appliance to the stipulated water
pressure only (see chapter “Connecting
the appliance”, section “Water connection”).
Screen on the water supply is dirty.
Call customer service.
Temperature in the freezer compartment
is too warm.
Set temperature slightly colder in the freezer
compartment.
Ice cubes have accumulated on the rear
panel of the ice cube container.
Distribute ice cubes in the ice cube container. If
ice cubes are stuck to each other, loosen with a
blunt implement.
The ice maker does not make any
ice.
Screen on the water supply is dirty.
Call customer service.
The ice maker is switched off.
Switch the ice maker on at the control panel.
The appliance is not supplied with water. Contact the installer or the water supply
company.
Water supply has kinks.
Turn off the water supply at the shut-off valve.
Smoothen out the kinks, exchange where
necessary.
Low water pressure.
Connect the appliance to the stipulated water
pressure only (see chapter Connecting
the appliance, section Water connection).
Temperature in the freezer compartment
is too warm.
Set temperature slightly colder in the freezer
compartment.
Ice cube container is not properly
inserted.
Check the position, re-insert where necessary.
Incorrect shut-off valve installed.
Incorrect valves can cause low water pressure
and damage to the appliance.
Ice forms in the inflow hose
to the ice maker.
Low water pressure.
Connect the appliance to the stipulated water
pressure only (see chapter Connecting
the appliance, section Water connection).
Shut-off valve incorrectly opened.
Open shut-off valve fully.
Water runs from the appliance.
The water connection hose is not
properly sealed.
Replace the hose with a manufacturer’s
original part.
Incorrect shut-off tap installed.
Incorrect taps can cause low water pressure
and damage to the appliance.
