7
Installation and connection
en-us
5
Installation and connection
Installation and connection
Contents of package
After unpacking all parts, check for any damage during
transport.
If you have any complaints, please contact the dealer
from whom you purchased the appliance or our customer
service.
The delivery consists of the following parts:
▯
Built-in appliance
▯
Interior fittings (depending on model)
▯
Installation material
▯
Instruction manual
▯
Installation instructions
▯
Customer service booklet
▯
Guarantee enclosure
▯
Information on the energy consumption and noises
Technical data
Refrigerant, cubic capacity and further technical
specifications can be found on the rating plate.
"Getting to know your appliance" on page 10
Installing the appliance
Installation location
The weight of the appliance may be up to 500 kg
depending on the model. The base must be sufficiently
stable and should not give. If necessary, reinforce the
bottom.
Check built-in cut-out
The cut-out must fulfill these criteria:
▯
Anti-tilt bracket must be fitted
▯
Cut-out depth min. 24” (610 mm), for flush installation
25” (635 mm)
▯
rectangular
▯
stable – the side panels and the top must be min. 5/8"
(16 mm) thick and securely attached to the floor or
wall
▯
Depth of shortest side panels min. 4” (100 mm)
Side-by-side installation
Observe the specifications in the installation instructions
for a side-by-side installation.
If a partition wall is required between the appliances it
must be at least 5/8" (16 mm) wide.
