en
operation
14
Making ice cubes
Use only drinking water to make ice
cubes.
1.
Fill the ice cube tray with drinking
water up to ¾ and place in the
freezer compartment.
If the ice cube tray is stuck to the
freezer compartment, loosen it with
a blunt implement only (e.g. spoon
handle).
2.
To loosen the ice cubes, twist the
ice cube tray slightly or hold it
briefly under flowing water.
operation
7 Basic operation
operation
7.1 Switching on the appli-
ance
1.
Press .
a
The appliance begins to cool.
a
A warning signal sounds and
lights up because the freezer com-
partment is still too warm.
2.
Switch off the warning tone using
.
a
goes out as soon as the set
temperature has been reached.
3.
Set the required temperature.
→
7.2 Operating tips
¡
Once you have switched on the
appliance, the set temperature is
only reached after several hours.
Do not put any food in the appli-
ance until the set temperature has
been reached.
¡
The front panels of the housing are
temporarily heated slightly. This
prevents condensation in the area
of the door seal.
¡
When you close the door, a va-
cuum may be created. The door is
then difficult to open again. Wait a
moment until the vacuum is offset.
7.3 Switching off the appli-
ance
▶
Press .
7.4 Setting the temperature
Setting the freezer compartment
temperature
▶
Press / repeatedly until the
temperature display shows the re-
quired temperature.
The recommended temperature in
the freezer compartment is
−18 °C.
8 Additional functions
8.1 Automatic Fast freezing
With automatic Fast freezing, the
freezer compartment cools down to a
much lower temperature than in nor-
mal mode. This freezes food more
quickly.
The automatic Fast freezing switches
on if you place fresh food in the
frozen food container that is second
from the bottom, starting from the
right-hand side.
If the automatic Fast freezing is
switched on, lights up and in-
creased noises may occur.
After operation, the appliance
switches from automatic Fast freez-
ing to normal operation.
