15
Tools and accessories which
are needed
Scope of delivery
–
Installation manual
–
Operating instructions
–
Installation accessories
Additional accessories
Installation accessories for Side-by-Side installation
For permanent connection of two appliances, e.g. a freezer
next to a refrigerator.
Lateral additional heating
Necessary when the distance between two appliances
is less than 160 mm.
Connecting element for furniture doors
For connecting two furniture doors (see explanation
in Section “19. Preparing the furniture doors”).
It can be used for standard height furniture doors without
any preparation work.
Tools
–
T20 rechargeable screwdriver
–
T20 Torx screwdriver
–
T20 Torx-bit magnetic holder
–
8 mm socket wrench
–
Various size drills
–
Fixed spanner SW 13 mm
–
Adjustable spanner
–
Knife with an adjustable blade
–
Metal tape measure
–
Try square
–
60 cm and 120 cm spirit levels
–
Straight edge
for stand-alone appliances min. 120 cm long
for setting up two appliances Side-by-Side
min 200 cm long
Miscellaneous
–
Step ladder
–
Roll trolley, fork-lift trolley or sack trolley
–
Hammer drill for drilling holes into the wall and floor
–
Various size drills for various materials
–
Wood plank, (min. 8 x 10 cm) as an alternative anti-tip
device. Length should correspond to the width
of the installation niche
–
Various size wood screws
–
Screw (M8, at least 80 mm long), nut
–
Thin (1.5 mm), material suitable for protecting
the floor against damage (e.g. linoleum)
–
Suitable material for covering and protecting
the cabinets (e.g. protective film)
–
Adhesive tape
Note:
Before using, check whether the removed adhesive
tape leaves adhesive residue on the work surfaces!
Otherwise do not use on high-quality work surfaces.
