22
According to the subsurface:
Look for the supports on the rear wall of the niche
and mark the drill holes on the plank corresponding
to the position of the support.
or
Fasten suitable dowel into the rear wall.
Pre-drill.
Screw the plank onto the rear wall of the niche.
8.
Preparing the water connection
(only for appliances which require a water connection)
m
Warning
Turn off the main water tap in order to avoid damage
from escaping water.
Insert filter screen into the filter housing (
1.
).
Place seal in the filter housing and connect to the tap
(¾" threaded connection) (
2.
).
Using an open-end wrench, connect water supply hose
with seal to the filter housing (
3.
).
Lay the connection pipe. Always keep to the given
installed area in order to avoid damaging the
connection pipe when sliding the appliance in later.
9.
Attaching the edge protectors
In order to protect the edges of the installation niche,
attach the supplied protection ribs with adhesive tape.
10.
Side-by-Side set up
If a Side-by-Side set up of two appliances is envisaged,
connect the two appliances to one another now.
Detailed information on installation can be found in
the separate installation instructions for the installation
accessories for Side-by-Side installation.
The following work steps must be performed on two
interconnected appliances.
