28
17.
Fastening the plinth strip
m
Caution!
From the floor upwards, the maximum height of the
base strip is 10.1 cm. Never cover the ventilation slits
with the base panel. Risk of damage to the appliance.
Where necessary, cut the base strip to the required
length.
Attach base panel to the appliance.
Take the protective film off from the adhesive pads
on the Velcro strip.
Put the base strip onto the base panelling and
push firmly.
Measure the difference in depth
Y
between the base
panelling and the base strip of the adjacent lower
cabinets.
Remove the base panelling again.
Loosen the fastening joint of the base panelling.
Take out/slide in the joint around the measured
depth
Y
.
Screw the joint again tightly.
