30
Important information for furniture doors with cutout
(appliances with ice and water dispenser, wine storage
cabinets):
The cut edges of the door cutout must be protected before
humidity penetrates. To do this, use the means suitable
for the material and the shape of the furniture door
(e.g. edge veneer, edge sealant).
Connecting element for furniture doors
Instead of one large door, two furniture doors can be
mounted next to each other in the case of appliances
with a width of 76 and 91 cm. These furniture doors
are then connected using a metal strip on the rear.
This metal strip is available from your dealer as an instal-
lation accessory (Connection element for furniture doors).
Further information concerning this can be found in the
section “Tools and accessories which are needed”.
When attaching the metal strip to the furniture doors, watch
out for the maximum possible length of the screws and the
position of the drill holes. Always carry out screwing jobs on
the most stable part of the furniture door. Never screw into
fillings or similar areas.
Note:
If only one door is to be mounted to an appliance with
a width of 76 and 91 cm, attach the supplied sandwich
plate to the adjusting rib and fix into position.
20.
Loading the appliance door
When attaching the furniture doors it is recommended
to load the storage sections in the door with weights
in order to ensure that the when adjusting crack
dimensions turn out to be as precise as possible.
Loading recommendations:
Appliance width
Loading of the furniture
door
45.1 cm
10 kg
60.3 cm
15 kg
75.6 cm
20 kg
