Gaggenau RF411904, User Manual

18

en

       Alarm

Switching on Pull-to-open system

In an installation situation with handles you can select 
the Pull-to-open system. Your appliance will support you 
in opening the door as soon as you pull on the handle.

1

Open the menu item 

Automatic door opening

.

2

Select menu item 

Pull-to-open system

.

3

Press 

™

 button to open the menu item.

4

Select 

Opening force

.Here you can select the level 

of force required to activate automatic door 
opening.

Switching off automatic door opening

1

Open the menu item 

Automatic door opening

.

2

Select menu item 

Off

.

Home network

You can use this function to establish a connection 
between the refrigerator and your mobile device. 

~

 "Home Connect" on page 19

M

Alarm

Alarm

Door alarm

If the appliance door is open for a long time, the door 
alarm switches on. A message appears on the control 
panel.

Turning off the door alarm

▯

Close the door.

Note: 

To mute the door alarm, you only have to 

acknowledge the message on the control panel. If the 
door remains opens a few more minutes, the message 
will appear again.

Temperature alarm

If the freezer compartment becomes too warm, the 
temperature alarm is switched on. A message appears 
on the control panel.The message shows the warmest 
temperature reached in the freezer compartment.

Caution!
Bacteria may develop during the defrosting process 
and spoil the frozen food

Do not refreeze food after it has been defrosted or 
started to defrost.

Refreeze food only after cooking. Do not store frozen 
food for the maximum storage period.

Note: 

The alarm may be actuated without risk to the 

food in the following cases:

–

The appliance is put into service and does not yet 
contain any food.

–

Large quantities of fresh food are placed in the 
appliance.

–

The freezer compartment door has been open too 
long.

Switching off the temperature alarm

1

Check that the cause of the temperature alarm has 
been eliminated.

2

Press 

™

 button to acknowledge the message.

The message disappears. The control panel again 
indicates the set temperature.

From this time on, the warmest temperature is measured 
again and saved.