Gaggenau RF463905, User Manual

9

 Installation and connection      

en

Before using the appliance for the 
first time

1

Remove information material, adhesive tape and 
protective film.

2

Clean the appliance.  

~

 "Cleaning" on page 26

Water connection

Caution!

–

Installation and connection of the appliance must 
be carried out by qualified technicians according to 
the installation instructions supplied.

–

To avoid damage to the appliance and to ensure its 
proper functioning, it should only be connected to a 
drinking water system.

–

To avoid water damage, a shut-off valve must be 
installed.

Water pressure of drinking water system

Caution!

If the water pressure exceeds the maximum value, a 
pressure relief valve must be installed between the 
drinking water connection and the hose set to avoid 
damage to the appliance.

Note: 

If the water pressure is too low, this will impair 

the appliance functions.

▯

Min. 0.2 Mpa (2 bar/29 psi)

▯

Max. 0.8 Mpa (8 bar/116 psi)

Electrical connection

Caution!

Do not connect the appliance to electronic energy saver 
plugs.

Note: 

The power source used by the appliance must not 

be a roof solar power generation or electricity 
conservation system.
Please connect the appliance to Taipower´s power 
network.

1

After installing the appliance, wait at least 1 hour 
before connecting it to avoid damaging the 
compressor.

2

Connect the appliance via a correctly installed 
socket.
The socket must comply with the following data:

Outside Europe: Check whether the indicated 
current type of the appliance corresponds with the 
values of your power supply. Appliance 
specifications are on the rating plate. 

~

 "Getting to know your appliance" on page 10

3

Connect the appliance to a socket near the 
appliance.
The socket must also be freely accessible after 
installation of the appliance.

m

Warning – Risk of electric shock! 

If the length of the mains cable is insufficient, do 
NOT use multi-outlet power strips or extension 
leads.Instead, please contact Customer Service for 
alternative solutions.

Socket with 

220 V ... 240 V

Conductor

60 Hz

Fuse

10 A ... 16 A