Basic operation
en
15
Tip:
You can use up to five bottle
trays on an extendable shelf.
Ice cube tray
Use the ice cube tray to make ice
cubes.
Making ice cubes
1.
Fill the ice cube tray with water up
to ¾ and place in the freezer com-
partment.
If the ice cube tray is stuck to the
freezer compartment, loosen it with
a blunt implement only (e.g. spoon
handle).
2.
To loosen the ice cubes, twist the
ice cube tray slightly or hold it
briefly under flowing water.
Basic operation
7 Basic operation
Basic operation
7.1 Switching on the appli-
ance
1.
Press .
a
The appliance begins to cool.
2.
Set the required temperature.
→
7.2 Operating tips
¡
Once you have switched on the
appliance, the set temperature is
only reached after several hours.
Do not put any food in the appli-
ance until the temperature has
been reached.
¡
The housing to the left, the right
and beneath the cool-fresh com-
partment may heat up slightly tem-
porarily. This prevents condensa-
tion in the area of the door seal.
¡
When you close the door, a va-
cuum may be created. The door is
then difficult to open again. Wait a
moment until the vacuum is offset.
7.3 Switching off the appli-
ance
▶
Press .
7.4 Setting the temperature
Setting the refrigerator
compartment temperature
▶
Press / repeatedly until the
temperature display shows the re-
quired temperature.
The recommended temperature in
the refrigerator compartment is
4 °C.
Setting the cool-fresh
compartment temperature
Note:
The standard setting of the
cool-fresh compartment is preset at
0. Setting 0 corresponds to a temper-
ature of around 0 °C. You can set
the temperature in the cool-fresh
compartment to 3 settings warmer or
colder.
A change in the standard setting will
affect the temperature in the refriger-
ator compartment and the freezer
compartment.
Tip:
If frost forms on the food items
in the cool-fresh compartment, set a
higher cool-fresh compartment tem-
perature.
