Gaggenau VF 411-610, Operation And Assembly Instructions

Installing the appliance

Fitting the appliance cover

• Firmly plug the connecting cable in the appliance

and in the control panel (the plugs must lock into
place).

• Turn the clamping screws to the side. Insert the

appliance with the control panel on the front into
the cut-out and align it. 

Note: 

do not stick the appliance onto the worktop

with silicone.

• Turn the clamping screws under the countertop

and tighten them evenly. Do not tighten the
clamping screws too tightly, as a uniform sealing
gap should be left all round.

• Connect the appliance to the electricity. Test that

it functions correctly. If the luminous discs behind
both control knobs blink, check the connecting
cable between the appliance and the control
panel is firmly plugged in.

Fitting the appliance cover

• The securing brackets are already fitted on the

base.

• Place the appliance cover on the brackets in

upright position and screw it down using the 
pre-mounted grub screws.

• Close the appliance cover. It must lie evenly on

the appliance.

• If the cover is not fitted straight, loosen the sheet

metal screws again and fit the included shims on
the securing bracket until the appliance cover lies
evenly on the panel edge.

• Again firmly screw down the appliance cover.

Note:

do not use the appliance cover as a surface for 
placing objects or for keeping things warm. Wipe
away spills before opening the appliance cover. 
Do not close the appliance cover until the 
appliance has cooled down completely. Do not 
operate the appliance with the cover closed! This
may damage the appliance and the cover due to
the development of heat.

9000030309     en 08.04 EB

19