Installing the appliance
Fitting the appliance cover
• Firmly plug the connecting cable in the appliance
and in the control panel (the plugs must lock into
place).
• Turn the clamping screws to the side. Insert the
appliance with the control panel on the front into
the cut-out and align it.
Note:
do not stick the appliance onto the worktop
with silicone.
• Turn the clamping screws under the countertop
and tighten them evenly. Do not tighten the
clamping screws too tightly, as a uniform sealing
gap should be left all round.
• Connect the appliance to the electricity. Test that
it functions correctly. If the luminous discs behind
both control knobs blink, check the connecting
cable between the appliance and the control
panel is firmly plugged in.
Fitting the appliance cover
• The securing brackets are already fitted on the
base.
• Place the appliance cover on the brackets in
upright position and screw it down using the
pre-mounted grub screws.
• Close the appliance cover. It must lie evenly on
the appliance.
• If the cover is not fitted straight, loosen the sheet
metal screws again and fit the included shims on
the securing bracket until the appliance cover lies
evenly on the panel edge.
• Again firmly screw down the appliance cover.
Note:
do not use the appliance cover as a surface for
placing objects or for keeping things warm. Wipe
away spills before opening the appliance cover.
Do not close the appliance cover until the
appliance has cooled down completely. Do not
operate the appliance with the cover closed! This
may damage the appliance and the cover due to
the development of heat.
5080009659 en 07.04 EB
17
