14
8.2 Connecting the appliance
8.2.1 Gas connection
8.2.2 Electrical connection
Gas connection
The gas connection must be in a location that
permits access to the shut-off valve and which, if
applicable, is visible after opening the door of the
furniture item.
By means of the included R 1/2” connection bracket
(on the appliance end) with the affiliated washer,
the appliance must be connected to a fixed
connecting line or a gas safety hose to DIN 3383
Part 1 that corresponds to the type concerned.
An ambient temperature of 70 °K must not be
exceeded if the gas safety hose consists only partly
of metal. The permissible ambient temperature for
a gas safety hose that consists completely of metal
is 115 °K.
If a flexible line is used, it must be laid in such a
way that it cannot come into contact with moving
parts of the kitchen element (e.g. drawer).
Electrical connection
Electrical connection (AC 220-240 V) is established
by means of a connecting cable with an earthing
contact plug connected to an earthed socket, which
must also be accessible after installation of the gas
hob.
If, after installation of the gas hob, not all poles can
be isolated from the mains by removing the plug,
an isolating device with a contact gap of at least
3 mm must be permanently installed. When
establishing connections, make sure that the
connecting lead cannot come into contact with hot
parts of the gas hob or other hot parts.
If damaged, the mains cable must be replaced by
a special mains connecting cable. The mains
connecting cable must only be connected by the
manufacturer or the manufacturer's after-sales
service.
The mains connecting cable must at least
correspond to the type H05-VV-F-3G 0.75.
40
103
Fig. 7
Seal
1/2”
