10
en-us
Installation Procedure
Installing the heat shield
9
CAUTION
Sharp edges. Use protective gloves when installing
the plate.
For safety reasons, the heat shield must be properly
installed when closed cabinets are used. This prevents
components from overheating as a result of the
recirculation of hot air from the cooktop.
The heat shield is the same width as the cooktop. For
shipping, it is screwed to the bottom of the burner box.
After unpacking the cooktop, unscrew the heat shield.
The heat shield will be able to rotate freely, as shown in
the illustration.
Install Appliance
9
WARNING
Before you plug in an electrical cord or turn on
power supply, make sure all controls are in the OFF
position.
1.
Connect the connection cable to the control cable in
the socket on the bottom of the appliance. The plug
must snap into place.
2.
The appliance must be secured from below using the
hold-down brackets provided, so it does not slip.
Position the appliance so that the screws provided are
seated loosely in the holes.
3.
Move the hold-down brackets so that the appliance
can be placed in the cutout.
(
)
