Installation instructions
en
39
26.14 Connecting connection cables to the
appliance
ATTENTION!
Heat may damage the appliance's connection cables.
▶
Ensure that the connection cables do not touch any
hot parts of the hob or oven.
▶
Install an intermediate floor so that the connection
cables are no longer accessible after the hob has
been installed.
1.
Connect the connection cable for any of the control
knobs to the appliance's socket.
2.
Ensure that the plug engages in the socket.
26.15 Installing the appliance
WARNING ‒ Risk of electric shock!
If the insulation of the power cord is damaged, this is
dangerous.
▶
Never let the power cord come into contact with hot
appliance parts or heat sources.
▶
Never let the power cord come into contact with
sharp points or edges.
▶
Never kink, crush or modify the power cord.
1.
Keeping the appliance level, insert it into the unit
cut-out.
2.
If the oven is a built-under type, route the mains
connection cable along the rear corners of the oven
to the mains socket.
26.16 Aligning the appliance
1.
Attach the retaining clips supplied and tighten them
carefully.
Do not use an electric screwdriver.
2.
Align the hob with the working surface using the re-
taining clips.
3.
Use the enclosed spacers to adjust the circumferen-
tial gap between the appliance and the worktop to a
uniform distance of 1.5 mm.
26.17 Establishing the power supply
1.
Observe the connection data on the rating plate.
