Gaggenau VI492115, User Manual And Installation Instructions

en 

Flex Zone

14

Preheating setting

Power level

Fondue

Cheese fondue

6

3-4

Chocolate fondue

8

3-4

Making sauces

e.g. teriyaki sauce

-

2-3

Keeping warm

-

1-2

11  Flex Zone

You can use the Flex cooking zone as a single cooking
zone or as two independent cooking zones. The Flex
cooking zone consists of four inductors. The inductors
work independently of each other and only activate
area of the hob that is covered by the cookware.

11.1 Cookware positions for a single
cooking zone

This is where you can find an overview of the position-
ing of the cookware.
In order to guarantee good pot detection and heat dis-
tribution, position the cookware in the centre.

For a diameter of up to
13 cm, position the cook-
ware on one of the four
positions as shown in the
illustration.

For a diameter over
13 cm, position the cook-
ware on one of the three
positions as shown in the
illustration.

If the cookware covers
more than one cooking
zone, position the cook-
ware starting on the up-
per or lower edge of the
flexible cooking zone.

11.2 Cookware positions for two
independent cooking zones

This is where you can find an overview of the position-
ing of the cookware.
You can use the front and rear cooking zones with two
inductors each independently of each other. Set the re-
quired power level for each individual cooking zone.

Use just one item of cook-
ware on each cooking
zone.

11.3 Using the Flex cooking zone as a
single cooking zone

Requirement:

 The cooking zones are connected. 

→ 

"Connecting the two cooking zones", Page 14

▶

Use the entire cooking zone.

Connecting the two cooking zones

1.

Set down the cookware.

2.

Turn one of the control knobs to  ​⁠.

3.

Use the other control knob to select the power level.

a

​⁠ lights up.

a

The power level lights up in the displays for both
cooking zones.

a

The Flex cooking zone has been activated.

Changing the power level

▶

Change the power level using the same control
knob that you used to select the power level.

Adding new cookware

1.

Set down the new cookware.

2.

The control knob is currently turned to  ​⁠. Turn it to 0
and then back to  ​⁠.

a

The hob detects the new cookware and the heat
setting that was previously selected is retained.

Note: 

If you move or lift the item of cookware onto the

active cooking zone, the cooking zone automatically
starts searching and the power level you selected pre-
viously is retained.

Separating the cooking zones

▶

The control knob is currently turned to  ​⁠. Turn it to
0.

a

The  ​⁠ display lights up.

a

The Flex cooking zone is deactivated.

a

The two cooking zones operate as two independent
cooking zones.

Note: 

If you switch off the cooking zone and switch it

back on again, the flexible cooking zone is switched
back to two independent cooking zones.