en
Installation instructions
34
26.8 Combining multiple appliances
Requirement:
You need a suitable connection strip to
combine several Vario appliances. You can obtain the
connection strip as an optional accessory.
1.
When making the unit cut-out, allow extra space for
the connecting strip between the appliances.
‒
Observe the installation instructions for the con-
nection strip.
2.
If required, install the appliances in individual cut-
outs.
‒
Maintain a bar width of at least 50 mm between
the individual cut-outs.
26.9 Installation accessories
Here, you can find an overview of the installation ac-
cessories.
Use the accessories only as specified. The manufac-
turer shall accept no liability if you use the accessories
incorrectly.
Accessories
Order number
Connection strip for flush
installation
VA420004
Connection strip for sur-
face-mounted installation
VA420010
26.10 Preparing the unit
ATTENTION!
A fan is located on the underside of this hob.
▶
If a drawer is located on the underside of the hob,
do not store any small or pointed objects, paper or
tea towels in it. These objects may be sucked in
and damage the fan or impair the cooling.
▶
There must be a clearance of at least 2 cm between
the contents of the drawer and the fan entry point.
Requirements
¡
The fitted units are heat-resistant up to 90 °C.
¡
The worktop is level, horizontal and stable.
1.
Follow the instructions on combining several appli-
ances.
→
"Combining multiple appliances", Page 34
2.
Ensure that the thickness of the worktop corres-
ponds to the required minimum thickness.
3.
Maintain the minimum clearance from the upper
edge of the worktop to the upper edge of a drawer
installed below it.
Summary of Contents for VI492115
Page 1: ...en User manual and installation instructions VI492115 Induction hob Gaggenau...
Page 42: ......
Page 43: ......
