Installation instructions
en
15
4.
Make the unit cut-out in the worktop for one or more
Vario appliances in accordance with the installation
drawing.
5.
Ensure that the angle of the cut surface to the work-
top is 90°.
6.
The cut-out edges at the sides must be flat to en-
sure that the retaining springs sit correctly on the
appliance.
7.
For multi-layer worktops, affix appropriate strips to
the side in the unit cut-out, if required.
8.
Remove dust and residues from the cut-out work.
Seal the cut surfaces so that they are heat-resistant
and waterproof.
9.
Ensure that the minimum clearance from the bottom
of the appliance to furniture parts is 10 mm.
10.
Use suitable substructures to ensure the load-bear-
ing capacity and stability of the unit, particularly in
the case of thin worktops.
‒
Take the appliance weight, including additional
load, into consideration.
‒
Use heat-resistant and moisture-resistant rein-
forcement material.
Note:
Only check that the appliance is level once it has
been installed in the installation opening.
Making the cut-out for the control knob
1.
Create the holes for the control knob in accordance
with the enclosed instructions.
2.
If the panel is more than 23 mm thick, cut out the
rear of the front panel for the retaining plate.
3.
Note the clearances between the control knobs.
4.
After making the cut-outs, remove any shavings.
5.
Seal the cut surfaces so that they are heat-resistant
and waterproof.
12.13 Installing the control knob
1.
If required, and depending on the distance between
the control knobs, break off the retaining plate at the
perforation.
2.
Hold the retaining plate in place against the rear of
the control panel.
