en
Installation instructions
16
3.
When fitting an individual control knob, use 2
screws to hold the retaining plate in place and pre-
vent it from rotating.
‒
In the case of stone worktops, stick the retaining
plate using heat-resistant, two-component adhes-
ive.
4.
Remove the protective film from the rear of the illu-
minated ring.
5.
Install the control knob in the correct sequence.
0
2
4
0
2
2
0
2
0
0
1
6
0
1
2
0
18
0
6.
Push the control knob into the hole.
‒
Always position the side marking on the control
knob on the left.
7.
Ensure that the retaining lug on the retaining plate is
located on the upper side and the control knob is in
the zero setting.
8.
On the rear of the control knob, tighten the retaining
nut using the installation tool provided.
9.
Align the control knob precisely in the zero setting.
12.14 Connecting the control knob to the
connection cables
1.
Connect all of the control knobs to the enclosed
shorter connection cables.
The two connectors on the control knob are
identical.
2.
Ensure that the plugs snap into place in the con-
nectors.
3.
Attach the longer connection cable to one of the
control knobs to connect it to the appliance.
You can connect the appliance to any control knob.
4.
Ensure that the plug engages in the socket.
5.
After installation, check that all of the plug connec-
tions are seated correctly.
6.
To fix all connection cable in place after installation,
bend the lugs on the retaining plates.
