Technical data
Total connected load: 3 000 W
AC 208/220-240 V / 60 Hz
Important notes on installation
This appliance can be combined with all Gaggenau
Vario 400 Series appliances.
This appliance may be installed in kitchen
combinations made of wood or similar combustible
materials without taking additional safety measures.
The built-in furniture and worktop where the
appliance is installed must be heat resistant up to
temperatures of 200° F/90° C.
The appliance must only be connected by an
authorised specialist, paying attention to the
relevant regulations of the power supply companies
and the regional construction regulations.
When connecting electrical appliances in the
proximity of cooking surfaces, make sure that
connecting cables do not come into contact with hot
cooking surfaces.
The installation technician is responsible for the
correct functioning of the appliance at the place of
installation. He must instruct the user on how to
disconnect the appliance from electricity in an
emergency.
After unpacking, check the appliance for any
transportation damage and report this immediately
to the transportation company.
Only install the grill with the appliance cover fitted.
The appliance cover serves as a heat shield to the
back wall during use.
There must be a gap of at least 12 ´ ´ / 300 mm at the
side between the appliance and any walls or
furnishings.
Note:
when installing a shelf, a distance of at least
13
/
16
´ ´ (20 mm) from the bottom edge of the housing
trough to the shelf or the next combustible item of
furnishing is needed.
If all poles of the appliances cannot be isolated
from the mains by removing an accessible plug, an
isolating device with a contact gap of at least 3 mm
must be installed (e.g. domestic fuse).
No warranty claims can be considered for any
damage resulting from failure to observe these
instructions. Read the “Important notes" on
page 3 and 4.
Subject to technical change without notice
Electrical connection
Only a qualified electrician should install this
appliance.
This appliance must be hardwired.
The mains connecting cable must at least
correspond to the type SJTO 3x16 AWG 105°C.
The mains connecting cable must only be
purchased through and connected by an
authorised specialist. The appliance must be
properly grounded. Read the information on
the rating plate.
15
9. Installation
Summary of Contents for VR 421-611
Page 1: ...Operating and Assembly Instructions VR 421 611 Electric Grill...
Page 2: ......
Page 23: ......