Installation instructions
en
17
3.
Position the retaining plate on the fitted unit.
‒
Place the angled lower edge of the retaining
plate on the bottom of the unit.
‒
Align the centre marking to the retaining plate at
the marked centre of the bottom of the unit.
4.
Mark the 6 holes on the front edge of the fitted unit.
5.
Countersink the 2 middle holes.
6.
Drill the 4 holes for the stop buffers.
Fitting tilt protection
1.
Measure and mark a clearance of 520 mm from the
front edge of the unit.
2.
Screw the two brackets into the elongated hole on
the mark.
3.
Place the appliance on a flat surface.
4.
Unscrew the two lower screws on the back of the
appliance.
Summary of Contents for WS061102
Page 1: ...en User manual and installation instructions WS061102 Warming drawer Gaggenau...
Page 21: ......
Page 22: ......
Page 23: ......